Gasboy CFN III Quick Reference Guide v3.3 Manual de usuario descargar pdf (Pagina 41)

CFN III Quick Reference

MDE-4483 CFN III Quick Reference Guide v3.3 · August 2005 Page 37

ANSI Setup

FKey Lock Off Print National

Feature Lock Off Send All

Keypad Numeric Send Area Screen

Cursor Keys Normal Print Area Screen

Xfer Term EOS Send Term None

Char Mode Multinational Print Term None

Keys Typewriter Print Mode Auto/Normal

VT 100 ID VT 100 Auto Answerback Off

Any commands run at the Site Controller will not be

logged unless you:

• direct output to the logger (use >log with the

command), or

• press CTRL - SHIFT - PRINT SCREEN

simultaneously. Pressing these keys toggles the

Main port output to the logger. (The message

line at the top of the screen toggles between FDX

MAIN and FDX>AUX.)

All other parameters should be set as shown above.

Island Card

Reader I

CPU Board

Part number: C05375.

Switches

DIP Switch Bank 2

DIP switch 2 on the reader terminal CPU board sets

options, including the reader terminal address:

Position & Definition Setting(*=customary)

1 see below *open

2 decimal point

*open=enable

closed=disabled

3 DES PIN encryption

*closed=disabled

open=enabled

4 reader type see below

5 gate reader

*open=disabled

closed=enabled

6 reader type see below

7-10 address see below

Reader Type 2-4 2-6

mag swipe without optical closed closed

mag swipe with optical closed open

mag insert open closed

optical closed open

Notes

Position 2-1 is not used in SC II software versions

1.0 and later. (In software versions 0.2 and before, 2-

1 is the deadman timer switch: open

(default)=enabled, closed=disabled.)

Position 2-5—In SC II software versions 0.2 and

before, 2-5 is the CRC switch; open=CRC enabled,

closed= disabled.

Address 2-7 2-8 2-9 2-10

1 cl cl cl cl

2 cl cl cl op

3 cl cl op cl

4 cl cl op op

5 cl op cl cl

6 cl op cl op

7 cl op op cl

8 cl op op op

9 op cl cl cl

10 op cl cl op

11 op cl op cl

12 op cl op op

13 op op cl cl

14 op op cl op

15 op op op cl

16 op op op op

Jumpers

Jumper Function and/or Normal Setting

K1 Position 1=LCD display

Position 1 and 2=Beckman alphanumeric

display

K2, K3 K2 in position 2 and K3 in position 1=Omron

reader

K2 in position 1 and K3 in position

2=Magstripe reader

K4 ----

K5 Position 2=2K RAM; position 1=8K RAM

K6 Jumpered when using motorized reader

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 63 64

Comentarios a estos manuales

Sin comentarios

Gasboy CFN III Quick Reference Guide v3.3 Manual de usuario Pagina 41

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Gasboy CFN III Quick Reference Guide v3.3