
CFN III Quick Reference
Page 32 MDE-4483 CFN III Quick Reference Guide v3.3 · August 2005
Standalone
Receipt
Printer
Epson
Dip Switch Settings
Set 1
Switch Setting Function
1-1 OFF Data Errors
Print as “?”
1-2 OFF 4K Buffer
1-3 OFF DTR/DSR
Handshaking
1-4 OFF 8 Bits Data
Word
1-5 OFF Parity Check
Disabled
1-6 OFF Parity Odd
1-7 ON 9600 Baud
1-8 OFF Transmission
Speed
Set 2
Switch Setting Function
2-1 OFF Busy, Off Line
or Buffer Full
2-2 OFF Fixed Off
2-3 OFF Normal Print
Density
2-4 OFF Normal Print
Density
2-5 OFF Fixed Off
2-6 OFF Fixed Off
2-7 OFF Reset Pin 6
Disabled
2-8 OFF Reset Pin 25
Disabled
Star
Self Test
To start any Star printer’s self test and display its
switch settings, turn its power on while pressing
down on FEED.
Star (RS-422)
The part number is C06244; the adapter is C06243;
and the cable is C06242. This printer works with both
console CPU boards, C04832 and C05836.
This printer does not allow the use of a PIN pad. On
CPU board C05836, set the console printer/pad
configuration to none.
Configure as type 3 in the Reader configuration
program, menu 3 (parameters).
The Star printer has four DIP switch banks:
DIP Switch Bank 1. Positions 1-4 and 6 are always
closed; positions 7 and 8 are always open. Position 5
governs the height of the line feed: open=1/8 of an
inch; closed (default)=1/6 of an inch.
DIP Switch Bank 2. All 8 positions on DIP switch
bank 2 should always be closed, with the possible
exception of position 4, which sets the paper width:
closed (default)=3-inch or 3.25-inch paper; open=2.5-
inch paper.
DIP Switch Bank 3. Positions 1-4 and 6-8 should
always be closed; position 5 should always be open.
DIP Switch Bank 4. Switch 4, which has 4 positions,
sets the address of the printer, as shown in the
following chart. Note that the Star printer can never
be address 4.
Address 4-1 4-2 4-3 4-4
1 op Cl cl cl
2 cl Op cl cl
3 op Op cl cl
5 op Cl op cl
6 cl Op op cl
7 op Op op cl
8 cl Cl cl op
9 op Cl cl op
10 cl op cl op
11 op op cl op
12 cl cl op op
13 op cl op op
14 cl op op op
Jumper B and C on SW5 and SW6.
Comentarios a estos manuales