Gasboy CFN III Quick Reference Guide v3.3 Manual de usuario descargar pdf (Pagina 35)

CFN III Quick Reference

MDE-4483 CFN III Quick Reference Guide v3.3 · August 2005 Page 31

Option Menus Selections

console address 1 2 3 4

keyswitch type 4 position

2 position

cash drawer yes no

drawer switch type dr clo=sw closed

dr clo=sw open

beeper enabled disabled

alert beep type short long no no

alert beep repetition* 15 sec 8 sec

4 sec 2 sec

key click type short medium long none

LED color normal reversed

dead man timer on off

console printer/pad** none present

printer address 01 01-64

DES disabled enabled

receipt line feed, top 0 1-10

receipt line feed, end 10 00-18

receipt left margin 04 00-10

printer Star undefined

printer port serial parallel

decimal position .00 none .0 .000

decimal point period comma

ignore scan 57 36-59, 62-77, 99

ignore scan 99 36-59, 62-77, 99

* in version 5.3e

** for Star RS-422 printer, set to none

While an option in each group is displayed, pressing:

• ENTER selects the currently displayed option

and causes an option in the next group to display.

• 1 selects the next option in that group.

• 2 defaults to the first option in that group.

• 0 exits configuration mode and saves your

changes.

• PREV selects the currently displayed option and

displays the previous group.

• 7 returns you to the initial configuration display.

RS-422/485 Loopback Connector

Pin connections: 1 to 3 (black to green) and 2 to 4

(red to yellow).

Vacuum Fluorescent

Display

DIP switch bank 1 on the Check Point fluorescent

display board sets options:

VF Display on

Switch 1 Definition Console Cust. Display

1 ---- open open

2 ---- open open

3 TEST** open open

4 MASTER closed open

5 SLAVE open closed

6 ---- open open

7 ---- open open

8 ---- open open

**in version 3.0; position 6 activates the self test in

version 3.1.

Notes

1-3, TEST—If closed, the display performs a rotating

barber-pole-pattern self test. The last four characters

in the pattern have all dots lit.

1-4, MASTER—If closed, display transmits

characters via its serial interface as it displays them.

This switch should be closed on the display in the

Check Point if a remote display is used also.

1-5, SLAVE—If closed, display listens on its serial

interface and displays all characters received there.

This switch should be closed if a display is being

used as a remote display connected to the display in

the Check Point.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 63 64

Comentarios a estos manuales

Sin comentarios

Gasboy CFN III Quick Reference Guide v3.3 Manual de usuario Pagina 35

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Gasboy CFN III Quick Reference Guide v3.3