Gasboy CFN III Quick Reference Guide v3.3 Manual de usuario descargar pdf (Pagina 34)

CFN III Quick Reference

Page 30 MDE-4483 CFN III Quick Reference Guide v3.3 · August 2005

Switch Settings

CPU Board, Firmware 5.0 -5.2

CPU board assembly number: C04832.

DIP switch banks 2 and 3 on the Check Point CPU

board set options:

DIP Switch Bank 2

Position & Definition Setting(*=customary)

1 ____

2-3 key click see below

4 beeper *closed=enabled

open=disabled

5 cash drawer present *closed=yes

open=no

6 cash drawer type *open=Gasboy

7-8 address see below

Keyclick 2-2 2-3

none open open

short open closed

medium closed open

long closed closed

Check Point Poll Address Select

Address 2-7 2-8

1 open open

2 open closed

3 closed open

4 closed closed

DIP Switch Bank 3

Position & Definition Setting(*=customary)

1 ____

2 dead man timer

*open=enabled

closed=disabled

3 ____

4 self test mode

*open=disabled

closed=enabled

5 keyswitch type

*open=4 position

closed=2 position

6 off-hook beeps

closed=soft

*open=loud

7 off-hook color

*open=red

closed=green

8 off-hook beeper

closed=no

*open=yes

CPU Board, Firmware 5.3 & 5.4

CPU board assembly number: C05836.

There are no DIP switch banks on the Check Point

CPU board with this firmware version.

Pins 2 and 3 on K1 (next to U15) are normally

jumpered.

Any RS-232 (serial) printer connected directly to the

Check Point CPU board goes to P11; a parallel

printer goes to P12.

Check Point Test Mode

To begin a self test:

• turn keyswitch to MANAGER and press 00/NO

SALE, or

• disconnect the RS-422/485 connector, wait for

the Out of Service display, and press 00/NO

SALE.

0 self-test

1 memory test

2 beeper check

3 console card reader test

4 display test

5 keyboard test

6 test opening of cash drawer

7 check setting of switches (firmware 5.2)

configuration (firmware 5.3)

8 serial port/loopback test

CLEAR

printer test (ver. 5.4 and higher)

9 ends self test

00 manager key test (firmware 5.3 or later)

Configuration

In the self test with firmware 5.3, pressing 7 accesses

configuration mode. (If the Check Point has never

been configured or if its configuration has been

erased, it will go into configuration mode at power

up.)

The default selection is the first selection shown in

each of the following option groups:

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 63 64

Comentarios a estos manuales

Sin comentarios

Gasboy CFN III Quick Reference Guide v3.3 Manual de usuario Pagina 34

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Gasboy CFN III Quick Reference Guide v3.3