Gasboy Q Series Manual de usuario descargar pdf (Pagina 2)

020897 Rev. 06/12/03 Page 2

4. Behind the junction box, disconnect the existing vent tube and

remove the existing compression elbow in the pumping unit.

Install a 3/8” inverted flared fitting (item 9) into the pumping unit

where the compression elbow just been removed. Rotate the

new fitting at about 35° as shown in Figure 3.

Figure 3

5. Install the pre-assembled unit from Step 3 onto the underside of

the motor/pump platform. Using a ¼-20 x ½ Taptite screw

(item 8, feed through an existing hole in the platform that is

close to the flange and the left side column. Secure the unit

loosely. (Figure 4)

Figure 4

6. Connect the vent tube assembly with flared nuts (item 3)

between the pumping unit’s elbow and the bottom elbow of the

sump overflow assembly (item 1). (Figure 5: NOTE: Junction

box removed for visibility.)

Figure 5

1 2 3

Sin comentarios

Gasboy Q Series Manual de usuario Pagina 2